【ACE】ACE常用命令

常用基本配置

1.登陆配置

Login: admin                                                                                              //默认用户名admin

Password: admin                                                                                        //默认密码

       RG-ACE > enable                                                                                       //进入特权模式

       2.管理ip地址配置

        RG-ACE # net addr set

        MGT interface ip address[192.168.0.1]: 192.168.254.100                            //配置管理口IP地址

        MGT interface netmask[255.255.255.0]: 255.255.255.0                              //配置网络掩码

        MGT interface gateway [192.168.0.1]: 192.168.254.254                            //配置网关

        DNS primary []: 61.177.7.1                                                                     //配置主DNS，2.8.X版本必须配置

        DNS secondary []:                                                                                 //配置第二个DNS

        3.其他常用配置

RG-ACE # net adde show                                                                       //显视配置管理IP，网关，DNS

RG-ACE # sys mgt set  

Management server ip address [192.168.0.176]: 192.168.254.200              //指定ACE的管理服务器IP或者是ELOG服务器的IP

RG-ACE # sys mgt show                                                                        //显示sys  mgt  set 的配置结果

RG-ACE # net ping  

input destination ip address: 192.168.1.200                                             //测试网络是否可达

RG-ACE # sys password                                                                        //设置密码

RG-ACE # sys version                                                                           //查看版本信息

RG-ACE # sys reset conf                                                                      //恢复出厂设置

RG-ACE # sys status                                                                           //查看系统信息

RG-ACE # sys flash show                                                                     //查看CF卡中拥有哪些firmware

RG-ACE # sys boot set                                                                       //切换到老版本的firmware

RG-ACE # sys  boot show                                                                   //当前引导版本

RG-ACE # sys reboot                                                                         //重启机器

RG-ACE # net link show                                                                     //查看接口双工、速率